Setting the Time & Date on a Nortel Norstar Telephone System
- Details
- Parent Category: Support
- Category: Nortel
There are a couple of different ways access the time change feature, depending on the type of system you have. A programming template is provided below if you need it. Just cut-out the shaded areas as well as around the outside of the template. Once cut, place the template over the top 2 rows of buttons on your 7310 or 7324 telephone (typically lines 1 and 2 on your telephone).
After you enter programming mode, all methods are pretty much the same.
Access type 1: Press * * TIME (8463)
Access type 2: Press * * ADMIN (23646)
System displays Password & then you should enter 23646
Display shows 1.Sys speed dial
Press Next Display shows 2. Names
Press Next Display shows 3. Time and date
Press Show Display shows Time 16:24
On the Softkey under the display it says CHANGE
If you wish to change the time, press CHANGE, if not press NEXT
Once you pressed the CHANGE button the hour displays;
If you wish to change the hour, press CHANGE, if not press NEXT
Once you pressed the CHANGE button the hour is erased allowing you to enter the new time - enter the new hour in 24 hour format, when OK press NEXT
Once you pressed the NEXT button the minutes display;
If you wish to change the minutes, press CHANGE, if not press NEXT
Once you pressed the CHANGE button the minutes are erased allowing you to enter the new time - enter the new minutes, when OK press NEXT
Follow the same procedure for changing the date!
Programming template
Print this page, cut out the shaded areas with a utility knife and then cut around the outside box. After you're done cutting, place the template over the top 2 rows on your 7310 or 7324 telephone.
